•  Retrait gratuit dans votre magasin Club
  •  7.000.000 titres dans notre catalogue
  •  Payer en toute sécurité
  •  Toujours un magasin près de chez vous     
  •  Retrait gratuit dans votre magasin Club
  •  7.000.000 titres dans notre catalogue
  •  Payer en toute sécurité
  •  Toujours un magasin près de chez vous
  1. Accueil
  2. Livres
  3. Sciences humaines
  4. Sciences
  5. Technique
  6. Ingénierie & Technologie
  7. Use of Chlorine Dioxide and Ozone for Control of Disinfection By-Products

Use of Chlorine Dioxide and Ozone for Control of Disinfection By-Products

P Zhou, J Neemann
Livre broché | Anglais | Awwa Research Foundation Reports
177,45 €
+ 354 points
Livraison sous 1 à 4 semaines
Passer une commande en un clic
Payer en toute sécurité
Livraison en Belgique: 3,99 €
Livraison en magasin gratuite

Description

Control of disinfection by-products (DBPs) in drinking water is becoming increasingly critical as regulatory requirements are calling for higher levels of disinfection while at the same time mandating lower maximum contaminant levels of DBPs. Many utilities have switched to alternative disinfectants such as ozone and chlorine dioxide (ClO2) to minimize chlorinated DBPs. Contra Costa Water District undertook a full-scale demonstration study using ClO2 and ozone to evaluate the potential benefits of combining these two powerful oxidants. The principal research objective, stated broadly, was to evaluate the benefits of using ClO2 in combination with ozone. The specific objectives were to determine the extent to which ClO2 preoxidation of the raw water (1) reduced the ozone demand/dose, (2) reduced the bromate formation, (3) reduced the energy consumption, (4) resulted in chlorate ion formation from oxidation of chlorite ion, (5) maintained the filtration benefits of preozonation, and (6) reduced THM and HAA formation potentials. The full-scale demonstration was conducted at the 40 mgd Randall-Bold WTP, which is a direct filtration plant that uses preozonation (before coagulation) to enhance the filtration process and postozonation (after filtration) for primary disinfection. During the study, ClO2 was added to the raw water ahead of the preozonation contactor. The testing component of the study was divided into three phases that led to long-term full-scale operation using ClO2 in combination with ozone. Three preoxidation conditions were tested: 1.5 mg/L of ClO2 alone, the combination of 1.0 mg/L of ClO2 and 0.5 mg/L of ozone, and 1.0 mg/L of ozone alone. In addition, special full-scale testing was conducted to evaluate bromate mitigation techniques such as preoxidation with ClO2, pH adjustment, and ammonia addition.

Spécifications

Parties prenantes

Auteur(s) :
Editeur:

Contenu

Nombre de pages :
126
Langue:
Anglais
Collection :

Caractéristiques

EAN:
9781843398790
Date de parution :
23-05-05
Format:
Livre broché
Format numérique:
Trade paperback (VS)
Dimensions :
210 mm x 279 mm
Poids :
303 g

Les avis